The heating elements that are present in a water heating system tend to get damaged and dysfunctional. Therefore, replacing or repairing these heating elements is the best way to increase the life of your hot water system. Here are a few tips that you can follow to prevent any damage and thereby stop the requirement of hot water heat repair. This will also ensure your heating system to work in an efficient manner.
Three Simple Tips to Follow
1. Insulate the pipes:
Always make sure that the hot water pipes of your system are well insulated. This is important because it minimizes the heat wastage which increases the durability of the heating unit drastically. Along with that it even decreases electricity consumption a lot, thus helping you to save a lot of energy and money. When you save energy, the same will directly reflect on your electricity bills too.
2. Keep an eye on the temperature settings:
Always remember to have the temperature of your hot water unit at somewhere around 130-135⁰ F for bathing and about 140⁰ F while washing clothes, as a higher temperature than that is going to induce distilled form of water where the sediments formed from the water can lead to blockage of water pipes of the heating unit.
3. Check the Temperature Pressure Relief Valve:
The Temperature-Pressure valve is an essential component of the heating system which specifically avoids the building up of too much temperature or pressure inside the boiler. When you lift or lower the level of this valve then water comes out from the overflow pipe. After that you can raise the lever from the valve to remove the excess pressure that is occupied in the boiler. Once the pressure and water is removed, tape back the valve at its place and turn on the cold water heating supply.
Different Types of Hot Water Heat Repair
There are two major forms of problems that occur when the heating unit of your hot water system is damaged. Here, we are going to discuss the two and the easy ways to handle hot water heat repair.
- Not enough hot water: Many times, we realize that the hot water system is not producing enough hot water as it used to do earlier. This problem might seem to be quite difficult but it’s quite easy to resolve. For troubleshooting this problem, first you must check the dial of your heating system. After that, check the different parts of the heating pipe to ensure that there are no leakages. If there is no problem with either the dial or with the water pipes then the next thing that you must do is flush out the entire water that is present in the heating tank. This is important because it removes the mineral deposits that have been there blocking the flow of water. This will increase the efficiency of the hot water heating unit.
- Water smells bad and is discolored: If the hot water that come from the system gives out a strange or smell or a stink then there are three things that you have to check. First of all, check the source from which your heating system is getting the water. Next, check the water pipes to know if something is present there. Third, check whether there are any copper, iron and other minerals present in the system, as they can cause discoloration. If the problem is with the smell of the hot water only then don’t panic. This can happen at times because of the high concentration of sulfates in the operation of the anode of the water heater.
This blog help you to learn everything about hot water heat repair. Keep in touch to know more information about hot water systems.
.png)
